I/O Module Mezzanine Cards; Mezzanine Card Installation Guidelines - Dell PowerEdge M630 Owner's Manual

Figure 18. Installing the memory module
1. memory module
3. memorymodule ejector (2)
Next steps
1. Followthe procedure listed inthe After working inside your system section.
(Optional) Press F2 to enter the System Setup, and check the System Memorysetting.
2.
The system should have already changed the value to reflect the newly installed memory.
NOTE: If the value is incorrect, one or more of the memory modules may not be installed properly. Check to ensure
that the memory modules are firmly seated in their sockets.
3. Run the system memory test in the system diagnostics.
Related links
Safety instructions
Before working inside your system
After working inside your system

I/O module mezzanine cards

The blade supports avariety of optional mezzanine cards. If installed, the mezzanine card(s) must be used inconjunction with a
matching I/O module(s).
For more information about I/O modules, see "Guidelines for Installing I/O Modules" in the M1000e Enclosure Owner's Manual at
Dell.com/poweredgemanuals.

Mezzanine card installation guidelines

The blade supports two mezzanine cards:
• Mezzanine card slot C supports Fabric C. This card must match the fabric type of I/O modules installed in I/O module bays C1
and C2.
• Mezzanine card slot B supports Fabric B. This card must match the fabric type of I/O modules installed in I/O module bays B1
and B2.
The blade supports SFF mezzanine cards. x8 PCIe Gen 3 cards are supported.
2. memory module socket
65