Dell PowerEdge M630 Owner's Manual page 37

Option Description
X2Apic Mode
Enables or disables the X2Apic mode.
Dell Controlled Controls the turbo engagement. Enable this option onlywhen System Profile is set to Performance.
Turbo
Controls the number of enabled cores in each processor. This option is set to All by default.
Numberof Cores
per Processor
Specifies if the processor(s) support 64-bit extensions.
Processor 64-bit
Support
Specifies the maximum core frequency of the processor.
Processor Core
Speed
Processor 1
The following settings are displayed for each processor installed in the system:
Option
Family-Model-
Stepping
Brand
Level 2 Cache
Level 3 Cache
Number of Cores
Related links
Processor Settings
Viewing Processor Settings
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable RAID on your system.
Related links
SATA Settings details
System BIOS
Viewing SATA Settings
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1.
Turn on, or restart your system.
2.
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click SATASettings.
Related links
SATA Settings
SATA Settings details
NOTE: Depending on the number of installed CPUs, there may be up to four processor listings.
NOTE: Depending on the number of CPUs, there may be up to four processors listed.
Description
Specifies the family,model, and stepping of the processor as defined by Intel.
Specifies the brand name.
Specifies the total L2 cache.
Specifies the total L3 cache.
Specifies the number of cores per processor.
3