Dell PowerEdge M630 Owner's Manual page 103

1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver and the Hex nut driver-5 mm ready.
3. Followthe procedure listed in the Beforeworking inside yoursystem section.
4. Remove the following:
a. Processor(s) and heat sink(s)
b. Memory modules
c. Coolingshroud
d. Hard drive or SSDs
e. Hard drive or SSD backplane
f. Hard drive or SSD cage
g. PCIe extender or storage controller card
h. mezzanine cards
i. IDSDM or rSPI card
j. NDC
k. SD vFlash card
l. Internal USB key
5. Install an I/O connector cover on the I or O connector(s) at the back of the board.
WARNING: The processor and heat sink can become extremely hot. Be sure the processor has had sufficient time to cool
before handling.
WARNING: The memory modules are hot to touch for some time after the system has been powered down. Allow time
forthememorymodulestocoolbeforehandlingthem.
touching the components.
CAUTION: Donotliftthesystemboardbyholdingamemorymodule, processor, orothercomponents.
CAUTION: Temporarilylabel the hard drive or SSD before removal so that you can replace them in their original locations.
Steps
1.
Remove the screws on the system board that secure the system board to the chassis.
2.
Lift the system board by holding the connector end and orienting it upward.
3.
Remove the system board from the chassis by disengaging the USB connectors from the slots on the front wall of the chassis.
4.
Ensure that the I/O connector cover is still in place on the I or O connector at the back of the system board.
Handlethememorymodulesbythecardedgesandavoid
103