Dell PowerEdge M630 Owner's Manual page 111

Figure 61. Removing the NVRAM backup battery
1. positive side of battery
Figure 62. Installing the NVRAM backup battery
1. positive side of battery
Next steps
1. Install the following:
a. System board
b. IDSDM or rSPI card
c. NDC
d. mezzanine cards
e. Hard drive or SSD cage
f. Hard drive or SSD backplane
g. Coolingshroud
h. Hard drives or SSDs
2. Followthe procedure listed inthe After working inside your system section.
3. Enter the System Setup to confirm that the battery is operating properly.
Enter the correct time and date in the System Setup's Time and Date fields.
4.
5. Exitthe System Setup.
6. Totest the newly installed battery, remove the blade for at least an hour.
7. Reinstall the blade after an hour.
8. Enter the System Setup and if the time and date are still incorrect, see the Getting help section.
2. negative side of battery connector
2. negative side of battery connector
111