RGBlink VENUS X1 Quick Start Manual page 12

Send to receiver after choose the connection mode, observe the display screen and make sure if
display image is correct. If wrong, change the connection types. Then connect the Port D or Port U
of One Sending Card to LED Screen is finished.
The setting for port D1 is same as the above setting.
Rendering is as follows:
2. Connect the Port D and Port U of One Sending Card to LED Screen
(1) First, make sure the device is in normal operation.
(2) Choose the input source, for example, DVI.
(3) Connect one cable to Port D1, the other one to U1.
(4) Connect Port U1 of No.1 Sending Card to LED screen, the settings are same as Step 4 to Step 9 of
"Connect the Port D or Port U of One Sending Card to LED Screen".
(5) Connect Port D1 of No.1 Sending Card to LED screen, setting steps are as follows:
a. Turn the knob, and select <LED MANAGEMENT>:
b. Push the knob to confirm, turn the knob, select <SENDING CARD TYPE> in <QUICK
CONNECTION> option, push the knob to confirm, turn the knob, select the sending card type, for
example, select Linsn (VENUS X1 supports Linsn and Colorlight sender card, for Nova sender card,
it only support brightness and Gamma adjustment). Shown as follows:
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen, Fujian Province, P.R.C
SYSTEM
->LED MANAGEMENT
LANGUAGE/语言
FACTORY RESET
>>
>>
ENG
>>
11
Tel: 00865925771197
Email: sales@rgblink.com
Fax: 00865925788216
http://www.rgblink.cn