Split Setting - RGBlink VENUS X1 Quick Start Manual

Split Setting

SPLIT is used when multiple VENUS X1 are used in cascade mode. When do cascade, connect the
signals to the signal distributor first, and then connect from the outputs of the signal distributor to each
input of VENUS X1. User can also do cascade via DVI LOOP port, and it needs to select "DVI LOOP"
for <DVI1 OUTPUT> in menus. The operations are as follows:
Push the [SPLIT] button, the button LED light will turn on, and enter to the split function menus. Turn the
knob to choose the split mode, there are two split modes, fixed split and normal split.
FIXED SPLIT: Menus are as follows:
SPLIT: Split function, can choose "ON" or "OFF". System default "OFF".
HORIZONTAL SPLIT: Horizontal fixed split, choose it and push the number button to set the total
horizontal screen number.
VERTICAL SPLIT: Vertical fixed split, choose it and push the number button to set the total vertical
screen number.
SPLIT INDEX: Use can choose the split index, and the LED screen will show the corresponding image.
H SIZE: The width of the device when do split.
V SIZE: The height of the device when do split.
ADVANCE: H SIZE, V SIZE, H POS and V POS setting. If image quality distorts by improper operation,
it can be recover by reset.
NORMAL SPLIT: For normal split, user should enable the split function, that is, turn the knob, and set
the <SPLIT> as "ON", push the knob to confirm. System default "OFF". User can set the normal split in
the sub menus:
H TOTAL: LED screen Horizontal total size.
V TOTAL: LED screen Vertical total size.
H POS: This device display image Horizontal size.
V POS: This device display image Vertical size.
H SIZE: This device display image Width setting.
V SIZE: This device display image Height setting.
19
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax: 00865925788216
Email: sales@rgblink.com http://www.rgblink.cn