Using Take Mode; Special Effects Switching - RGBlink VENUS X1 Quick Start Manual

Using TAKE Mode

1. First, define the [SCALE] key as TAKE. For more details, please refer to:
Key.
2. After define SCALE key as TAKE, the SCALE button will light up.
3. Choose the signal that need to take, for example, push [DVI/5], the signal button you have selected
will flash and the main menu will show the TAKE source you have selected.
4. After choose the signal, push the [SCALE] ([TAKE]) button, and the signal will be taken to the output.

Special Effects Switching

Push the [MENU] button two times, and enter the effect switch function menus, effect menu shown as
follows:
DEINTERLACE: Force Deinterlace function, can choose "ON" or "OFF".
ON: Force deinterlace.
OFF: No deinterlace.
IMAGE ENHANCE: Image enhancement function, used for image edge sharpening, color reduction
and image scaling.
MODE: Special effects switching modes, including DISSOLVE, CUT, WIPE SOUARE IN, WIPE
SOUARE OUT, WIPE TOP LIEFT IN, WIPE TOP LIEFT OUT, WIPE TOP RIGHT IN, WIPE TOP RIGHT
OUT, WIPE BOTTOM LEFT IN, WIPE BOTTOM LEFT OUT, WIPE BOTTOM RIGHT IN, WIPE
BOTTOM LEFT OUT, WIPE LEFT IN, WIPE LEFT OUT, WIPE RIGHT IN, WIPE RIGHT OUT, WIPE
TOP IN, WIPE TOP OUT, WIPE BOTTOM IN and WIPE BOTTOM OUT:
FADE TIME: Switch time setting. Turn the knob to choose the time and push the knob to confirm. The
switching time ranges from 0 to 3S.
ALPHA: It can set the image transparency, the regulating range is among 0 to 16.
Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen, Fujian Province, P.R.C
25
Tel: 00865925771197
Email: sales@rgblink.com
User Define the SCALE
Fax: 00865925788216
http://www.rgblink.cn