User Defined Setup Overview (Manual) - FARMSCAN Jackal v2 General Description Manual

USER DEFINED SETUP OVERVIEW (MANUAL)

At any stage you can manually setup the Jackal to your requirements without using the wizards.
Manual setup of the Jackal requires setup in multiple areas follow the steps listed below.
1. INPUTS
a.
Select & enable the Input that sensors are connected into the rear of the Jackal.
2. CALIBRATE
a.
Calibrate each input following the TARGET or MANUAL RATIO method.
3. FRONT SCREEN
a. Define the order of lines, label, Unit of measure (UOM), decimal places & alarm points that you wish
to be displayed on the front screen. NB: You can display multiple UOM on the front screen using only
one input. e.g. View Ha & Ac at the same time.
4. OTHER SETTINGS
a. Use this to define implement width for Ha/Ac accumulation, External Run/Hold port (if being used),
alarm options & notifications, Language (English, French, German, Bulgarian)
5. OUTPUT
a. Use this only to setup the Jackal to output a pulse (radar), Alarm, batch/trip & external hold.
The Jackal can be setup in many ways. You can choose 1 UP, 2 UP & 3 UP screens, 0-3 Decimal places for
readouts, mix imperial & metric, label inputs, multiple pages of information, alarm points, trip functions &
MORE. The Jackal is designed to be as flexible as possible in different agricultural environments.
Example : 2 UP Area & Shaft (rpm)
September 2015
FRONT SCREEN > SETUP
www.farmscanag.com
User Defined Setup Overview (Manual)
Example: 3 UP Monitoring 2x Shaft & Wheel
input for HA
39
AM-JACKAL-3