Table of Contents
Advertisement
16
Area & Speed Meter Setup (Wizard)
CALIBRATION (AUTO SET)
1. Ensure that the sensor & pickup are end-end before continuing
2. Mark bottom centre of tyre on which the sensor is fitted and peg ground in corresponding position
3. Measure out a known distance to calibrate i.e. 20m
4. Peg the corresponding point i.e. at the 20m mark
Highlight TARGET & press
EDIT
Press CALC. This will divide
the distance travelled by the
number of pules registered.
You can choose to enable the
remote run/hold input
(Further info
PAGE
43) or edit
the AlarmBeep in seconds.
Press NEXT
September 2015
Using the NAV buttons enter
your measured distance. i.e.
20.0000
Press EXIT when done.
MANUAL RATIO will now be
updated to reflect the
calibration factor.
Press NEXT
Using the NAV buttons select
how you would like the area
to be displayed on the front
screen.
Press NEXT
www.farmscanag.com
Press START and move
forward slowly. This will allow
pulses to register.
For the Jackal to correctly
read hectares/acres an
implement width needs to be
entered. Press EDIT
(You can RIGHT NAV button
once & press EDIT to change
m to ft,yd,in)
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select & EDIT as
required. Press NEXT
When you arrive at the
center mark point of tyre to
peg press STOP
Using the NAV buttons enter
your implement width in
(m). e.g. 18m
Press EXIT when done
Name the input if you desire,
Press EDIT. e.g. WHEEL
Press NEXT
AM-JACKAL-3
Hide quick links:
Advertisement
Table of Contents
