Table of Contents
Advertisement
SLIPPAGE METER (WIZARD)
The Jackal can provide the operator with the ability to compare two inputs and provide the
result as a percentage. This is applicable when speed over ground is not necessarily equivalent
to rotational speed of the wheel/s. This will enable you to set up a comparison between wheel
speed and actual speed (using GPS)
Sensors Required:
Wheel sensor input (wheel or shaft pickup)
GPS
Available Connections
(PAGE
This setup section assumes that physical wiring for the required sensors have been
completed. If not please refer to
SETUP
From the front screen press
SETUP
Press the EDIT button to
change the baud rate, when
the correct baud rate is
selected the corresponding
NMEA message will be
acknowledged with a Y.
Press NEXT
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select & EDIT as
required. Press NEXT
September 2015
4)
PAGE 7 & 8
on wiring requirements
Highlight WIZARD & press
SELECT
As indicated, drive above
3km/hr
There is no need to EDIT the
name. It will default to GPS
Press NEXT
THIS ENDS THE SETUP WIZARD FOR WHEEL SLIPPAGE
www.farmscanag.com
Highlight SLIPPAGE METER
press NEXT
Wheel input will then
increment up (displayed in
Hz) & GPS speed will start to
show.
Finally acknowlege that you
wish to also display Speed
(km/hr) on the front screen
with the area covered.
Press YES
Slippage Meter (Wizard)
VERSUS
Highlight the INPUT number
X: the WHEEL sensor wire is
connected into on the rear
of the Jackal & press NEXT
As the system
self-calibrates the slip % will
get closer to 0%.
When the slip has settled
close to 0% press NEXT
The Wizard is now complete.
Press NEXT.
Press EXIT to return to the
front screen
AM-JACKAL-3
27
Hide quick links:
Advertisement
Table of Contents
