FARMSCAN Jackal v2 General Description Manual page 11

10 Connections
POWER CONNECTION
Power connection must come direct from the battery terminals. WARRANTY IS VOID if power is not
connected as described in this section.
1. Connect power cable supplied DIRECTLY TO BATTERY
2. Ring terminals are used for battery connection and the bare end used to connect to the rear Jackal.
(Refer above image for power connection)
3. Connect Ground to BATT -VE, Terminal B11 using the
4. Connect
5. Ensure that the battery connection to the Jackal is
September 2015
+12 Volts (+battery terminal) to BATT +VE, Terminal B10 using the
Connecting 24V to the Jackal will VOID WARRANTY
www.farmscanag.com
RED with BLACK stripe wire
+12 Volts
Disconnect the terminal plugs from
the Jackal if ARC WELDING
machinery
red wire
on
AM-JACKAL-3