Alarms (Explained) - FARMSCAN Jackal v2 General Description Manual

38

Alarms (Explained)

ALARMS (EXPLAINED)
Alarms are set on a per Display Value basis. High/Low Alarm points can be set for any value and will be
displayed visually & made audible.
During the wizard or manual setup you have the option to set an Alarm MIN & Alarm MAX.
Below is an example of a SHAFT alarm on input 1.
Wizard (Above) or Manual (Right) alarm points.
Example of a Shaft Alarm set at
Min of 1000rpm & Max of 3000rpm.
Press EDIT to adjust these values
When the alarm point is reached e.g.: over 3000rpm the
line will FLASH notifying you of the alarm point.
Press ALARM to enter the page showing all Alarms (active
and inactive) to reset the alarm.
September 2015
Manual/User setup Alarm points via the
MENU > FRONT SCREEN >EDIT Input #
In the example above Line 1 is ^ over the alarm set point.
=AUTO : As soon as the value moves back within the Min
& Max range the monitor will automatically reset the
alarm.
=ON : When the alarm is activated it will remain ON until
you enter the ALARM menu and manually reset
=OFF : You can disable the alarm altogether
www.farmscanag.com
If it was below it would show 1v.
You have 3 options :
AM-JACKAL-3