40
Inputs (Manual Setup)
INPUTS (MANUAL SETUP)
The Jackal has 13 available & selectable inputs. Refer to the sensor overview tables from
meter / pulse (m)
B1-B6
mile / pulse (mi)
B1-B6
pulse / Bushel (bu)
B1-B6
kPa / psi / bar / Volt
/ % / Temp ˚C
B7 & A7
13 Inputs are available on the Jackal
Refer to
When the input has been enabled, using the NAV buttons navigates you through the calibration setup.
Here you can also select your calibration method. N.B. Different inputs have different calibration methods.
TARGET
allows you to use the auto calibrate function and enter a known Unit Of Measure to calibrate pulses to. When the
known UOM is entered the start button can be used to count the necessary pulses.
Once the pulse have been counted press the CALC to auto update the MANUAL RATIO field.
MANUAL RATIO
allows you to enter a known calibration factor. This could be a pulse per litre factor for a flow meter, a
known wheel circumference for speed & area (pulse/m), or number of magnets for rpm.
September 2015
FRONT SCREEN > SETUP > INPUTS
feet / pulse (ft)
yard / pulse (yd)
B1-B6
B1-B6
pulse / Kilogram (kg)
pulse / US pound (lb)
B1-B6
B1-B6
pulse / rev (rpm)
pulse / bale (bale)
B1-B6
B1-B6
High/Low, On/Off,
Full/Empty
A2 & A6
PAGE 4-6
for input usage
CALIBRATION METHOD – TARGET & MANUAL RATIO
Review the wizard setups for example calibration methods
Inch / pulse (in)
B1-B6
pulse / litre (l)
B1-B6
pulse / unit (unit)
B1-B6
After selecting your input pressing the EDIT button allows
www.farmscanag.com
PAGES 4-9
kilometer / pulse (km)
B1-B6
pulse / US gallon (gal)
B1-B6
pulse / each (each)
B1-B6
you to enable/disable the port
AM-JACKAL-3