Overview - FARMSCAN jackal V3.5 Manual

OVERVIEW

BUTTON FUNCTIONS
1
1. Power On/Off button
a. Power is turned on by pressing the ON/OFF button for 1 second.
b. Power is turned off by holding the ON/OFF button for 2 seconds.
2. Run/Hold button
a. The RUN/HOLD button has a dual function.
a. Press RUN/HOLD once to place the 'MONITOR ON HOLD'.
b. Press RUN/HOLD again to resume operation.
b. The RUN/HOLD state is indicated in the top left hand corner of the screen. When the monitor is in
RUN mode, the unit displays RUN to signify that the monitor is active.
c. When the monitor is in HOLD mode the unit displays the word "HOLD" & "BEEPS" every 2 seconds
3. Page button
a. The PAGE button is not used in the Jackal Basic (Control Only)
4. Select button (3 of)
a. The Jackal has 3 soft buttons placed directly under the LCD. These buttons will change function in
different menus.
b. The function of the soft button is indicated at the bottom of the screen directly above the button.
5. Navigation button (Up, Down, Left, Right, Enter)
a. The Round navigation (NAV) buttons are used to navigate UP/DOWN/LEFT/RIGHT in calibration screens
as well as scrolling through the display lines on the main screen.
b. ENTER is used to select the option highlighted onscreen.
6
4
5
WWW.FARMSCANAG.COM
3
2
AM-JACKAL-B / OCT 2018