Table of Contents
Advertisement
AREA & SPEED METER SETUP (WIZARD)
The Jackal can display Speed & Area in any combination of km/mph or Ha/acre.
A pickup can be mounted either on a wheel hub or shaft. (Example image right)
NB : There should be a 5-10mm Clearance between sensor & magnet
Sensors Required
Wheel sensor pickup 2 (Reed) or 3 wire (Proximity)
Magnet (Used with 2 wire sensor)
Available Connections
(PAGE
This setup section assumes that physical wiring for the required sensors have
been completed. If not please refer to
SETUP
From the front screen press SETUP
Highlight the INPUT number the speed
is connected into the back of Jackal &
press NEXT
September 2015
4)
PAGE 7
on wiring requirements
Highlight WIZARD & press SELECT
Enable the input by pressing EDIT
Choose your calibration method :
Auto Set,
Manual Ratio
www.farmscanag.com
Area & Speed Meter Setup (Wizard)
Highlight Area/Speed Wheel & press
Choose your unit of pulse calibration
method (m,ft,yd,in,km,mi) by pressing
Next Page
or
(Page
18)
15
NEXT
EDIT
AM-JACKAL-3
Hide quick links:
Advertisement
Table of Contents
