Area & Speed Meter Using Gps Setup (Wizard) - FARMSCAN Jackal v2 General Description Manual

20 Area & Speed Meter Using GPS Setup (Wizard)
AREA & SPEED METER USING GPS SETUP (WIZARD)
The Jackal can display Speed & Area in any combination of km/mph or Ha/acre using an
external GPS source. A secondary sensor is not required.
GPS : Programmed with RMC or GGA+VTG NMEA messages.
Baud Rate : 4800,9600,19200,38400,115200
Available Connections
This setup section assumes that physical wiring for the GPS has been completed. If not
please refer to PAGE 7
SETUP
From the front screen press SETUP
Highlight WIZARD & press
SELECT
Using the NAV buttons enter
your implement width in (m).
Press EXIT when done
September 2015
(PAGE 4)
on wiring requirements
Highlight Area/Speed GPS &
press NEXT
You can choose to enable the
remote run/hold input
(Further info PAGE
Press NEXT
www.farmscanag.com
Press the EDIT button to
change the baud rate, when
the correct baud rate is
selected the corresponding
NMEA message will be
acknowledged with a Y.
Press NEXT
Using the NAV buttons select
how you would like the area
43) to be displayed on the front
screen.
Press NEXT
For the Jackal to correctly
read hectares/acres an
implement width needs to
be entered. Press EDIT
(You can RIGHT NAV button
once & press EDIT to change
M to FT,YD,IN)
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select & EDIT as
required. Press NEXT
AM-JACKAL-3