FARMSCAN Jackal v2 General Description Manual page 9

8 Connections
THREE WIRE "ANALOG/VOLTAGE" SENSOR KITS
(AA-114, AA-119-H, AA-119-L, AA-430)
These kits will all include an "analogue" style sensor. The
analogue sensor is a 3 wire sensor and uses a ground/earth
wire, a signal wire and a 12v power wire.
The diagram to the right shows which terminals to connect
your sensors to. If the ground/earth (A1) or regulated 12v
power (OUT2, B9) terminal already has a wire from another
sensor applied to it then you will need to piggy back onto this
wire. If the signal port (A7) has wires from another sensor
applied to it then move to one of the ports shown that is free.
(A8)
Use the GENERIC wizard to setup the port and calibrate a sensor once installed
THREE WIRE "BIN/TANK LEVEL" SENSOR KITS
(2060, A-2220P)
These kits will all include an "off/off, high/low, empty/full"
style sensor. The sensor is a 3 wire sensor and uses a
ground/earth wire, a signal wire and a 12v power wire.
The diagram to the right shows which terminals to connect
your sensors to. If the ground/earth (A1) or regulated 12v
power (OUT2, B9) terminal already has a wire from another
sensor applied to it then you will need to piggy back onto this
wire. If the signal port (A6) has wires from another sensor
applied to it then move to one of the ports shown that is free.
(A6-A2)
Use the GENERIC wizard to setup the port and calibrate a sensor once installed
GPS
(T-135)
GPS supplied from Farmscan Ag are pre-programmed with GGA,
VTG, RMC, 1Hz at a baud rate of 19200. Wiring consists of 12v
Power (B9), Ground (A1), Transmit "TX" which is then inserted
into the Receive "RX" (A11). If supplying your own GPS input to
the Jackal, (A11) is required only.
Use the wizard to setup the port and calibrate a sensor once
installed.
September 2015 www.farmscanag.com AM-JACKAL-3