Table of Contents
Advertisement
24
Flow Meter Setup (Wizard)
FLOW METER SETUP (WIZARD)
The Jackal can be configured to monitor liquid products. If only one input is used the
main screen will display the flow information is L/min or gal/min, or, if using the
speed & area function the Jackal can also display L/Ha or gal/Acre.
At no stage can the Jackal take into account multiple spray sections turning on and off
and adjusting the Ha/Ac to suit.
Refer to
PAGE 31
for Rate Monitor setup to display L/Ha
Sensors Required
Flow Sensor (2 or 3 wire)
Available Connections
This setup section assumes that physical wiring for the required sensors
have been completed.
If not please refer to
PAGE 7
NB. 3 wire flow sensors need to be in B2-B6. If a 2 wire flow sensor is being used, please use B1.
SETUP
This is example is using a 2 wire (Sine Wave/Coil) flow sensor into B1
From the front screen press SETUP
Highlight the INPUT number X: the
sensor wire is connected into on the
rear of the Jackal & press NEXT
September 2015
(PAGE
4)
on wiring requirements.
Highlight WIZARD & press SELECT
Enable the input by pressing EDIT
Choose your calibration method :
Auto Set
Manual Ratio
www.farmscanag.com
Highlight FLOWMETER & press NEXT
(Next
Page)
or
(PAGE
26)
Choose your unit of pulse.
pulse/L or pulse/gal
AM-JACKAL-3
Hide quick links:
Advertisement
Table of Contents
