Area & Speed Meter Using Gps Setup (Wizard) - FARMSCAN jackal V3.5 Manual

AREA & SPEED METER USING GPS SETUP (WIZARD)
The Jackal can display Speed & Area in any combination of km/Ha or mph/acre.
A wheel sensor is not required when using a GPS. GPS purchased from Farmscan
Ag are pre-programmed. If you BYO please ensure the following:
•
GPS programmed with RMC – GGA - VTG NMEA messages.
•
Any Baud Rate of - 4800,9600,19200,38400,115200
Available Connections -
SETUP
From the front screen press
SETUP
Press the EDIT button to
change the baud rate, when
the correct baud rate is
selected the corresponding
NMEA message will be
acknowledged with a Y.
Press NEXT
Press EDIT to change the
input name or
Press NEXT to continue
12
REFER TO PAGE 5
Highlight WIZARD and press
SELECT
Press EDIT to change the
input name or
Press NEXT to continue
Press the UP arrow to
highlight the width.
Press EDIT & use the NAV
buttons to change the
implement width. E.g. 12m.
Pressing EDIT will change the
Unit of Measure. Press NEXT.
WWW.FARMSCANAG.COM
Press NEXT
Select km/h or mph to display
the speed on the front
screen.
Press EXIT & NEXT to finalise
the setup of the Speed &
Area Wizard.
Select GPS
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select and EDIT as
required. Press NEXT
nd
If you have a 2 sensor
connected to Input 1 press
NEXT to continue the
wizard.
THIS ENDS THE
SETUP FOR SPEED/AREA
METER USING
GPS INPUT
AM-JACKAL-B / OCT 2018