Testing The Touchpoint Plus Wireless System; Introduction - Honeywell Touchpoint Plus Wireless Technical Handbook

3020M5001_Iss 1_07/18

8.2 Testing the Touchpoint Plus Wireless System

8.2.1 Introduction

The Touchpoint Plus system has two test modes available, which together enable a full test of the system.
The test modes are:
1) Field Inputs Test – tests all input channel devices and alarm levels without affecting any outputs. Gas test,
force mA, confirmation of correct device connection etc.
1)
Login with a valid engineer password.
2)
Set inhibit input channels
3)
Supply gases for the input channels
4)
System will display gas reading and inhibit state
5)
Pre-configured Inhibit output (relays channels will output inhibit state) will be triggered and all
alarm outputs are inhibited
2) Cause and Effect Test – forces the Touchpoint Plus input channels to specific states to test that the correct
output channels are activated.
The Touchpoint Plus system is not operational while in Test Mode, under test will be ignored.
Ensure that alternative safety arrangements are maintained during test, and ensure that Test Mode is exited as
Test outputs conditions will be simulated and relays will be activated during the Cause and Effect Test.
Ensure that relay activated output systems (i.e. emergency deluge / sirens etc.) are isolated before starting the
Once a test mode is active, the system will remain in test mode until the test is exited. The only exception is in
the case of a power cycle of the Touchpoint Plus system, when it will restart in normal mode.
All events generated while the system is in test mode will be logged in the event history. Therefore a record of
the testing can be generated once it is complete (see Normal Operation, Generate Reports).
Maintenance
soon as testing is completed.
Ensure that the system is returned to normal operation once testing is complete.
Warning
Caution
test.
Caution
66
Touchpoint Plus Wireless
Technical Handbook