How To Calibrate The Touch Panel; Service Contact Settings; Back Up Configuration - Honeywell Touchpoint Plus Wireless Technical Handbook

3020M5001_Iss 1_07/18

7.8.1 How to Calibrate the Touch Panel

Calibrate the touch panel if the screen is not responding as expected.
To calibrate the screen:
1) Login as an Engineer or higher access level
2) Select the Menu>configuration>Display
3) Touch 'Start' next to Touch Panel Calibration
4) Follow the instructions on screen.
5) Select Finish to return to the Configuration menu

7.9 Service Contact Settings

To set the Service contact:
1) Login as an Engineer or higher access level
2) Select the Menu>Configuration>General>Service Contact.
3) Update the settings with your local service support contact details.
4) Select Finish to return to the Configuration menu

7.10 Back up Configuration

Note: Engineer or higher access level is required for this procedure.
It is recommended you back up the Touchpoint Plus configuration once commissioning is completed.
To back up the configuration:
1) If it is safe to
2) Ensure that an empty 2 to 32 GB (FAT32) standard SD Card with sufficient free space is inserted in the
User interface module.
3) Login as an Engineer or higher
4) Select the Menu>Configuration>Config Manager>Export.
5) Enter file name for the backed-up configuration and Touch Finish.
6) Touch Export if the file name is valid. The backup may take several minutes, and progress is shown on
screen.
7) When backup is completed, remove the card and immediately fit a spare card to record event data.
8) Close the enclosure door and tighten the two handle security screws.
9) Return the system to normal operation.
10) Transfer the backup data to a dated folder on a PC or digital device for safekeeping. The Configuration
backup file is stored on the SD Card in '\\CFG\TPP_CFG.bin'
11) You can reuse the SD card once the data has been transferred to a PC or other device and deleted from
the card.
12) Restoring a configuration is the reverse process, i.e. Import instead of Export, but it can only be done by
an Administrator.
Commissioning
do, unscrew the handle security screws and open the enclosure door.
61
Touchpoint Plus Wireless
Technical Handbook