Honeywell Touchpoint Plus Wireless Technical Handbook page 94

3020M5001_Iss 1_07/18
Parameter Name
Cal Interval
Default Range
Detector Index
Detector Name
Formula Gas Name
Gas Digit
Gas Index
Gas Name
Gas Over Range Limit
Gas Type
Gas Under Range Limit
Gas Unit
Gas Unit Index
Group
Inhibit Timeout
Item Name
Lower Zero Dead Band
Configurable Parameter Reference Guide
Parameter Description
Recommended calibration interval in days. Default is 6 months
Full scale range.
Index of detector that is used internally
Detector name.
Formula for the target measuring gas
Index of decimal places for the gas relevant parameters
Pre-defined gas index. Internal parameter.
Target gas name
Over-range gas concentration limit. This parameter is used to
generate over-range warning
Toxic (0), O2 (1), Flammable (2)
Set automatically by Gas Name
Negative reading limit
Measurement unit Strings:
%, ppm, %LEL, %VOL, mA
Index of measurement unit
Type of sensor catalogue.
mV input = 0, mA input = 1
Inhibit timeout in minutes. 0 means permanent inhibit
Sensor catalogue name. Default name consists of <Detector Name>
and <Sensor Name>
Lower deadband range. The gas concentration within the deadband
limit will be suppressed to default base concentration. I.e. if the gas
concentration is between the (default base concentration - lower
deadband) and (default base concentration + upper deadband), then
the reading will be the default base concentration.
Applies to
All
All
All
All
All
All
All
All
All
All
All
All
All
All
All
All
All
88
Touchpoint Plus Wireless
Default Measurement
Read/Write
Value units
RW 180 days
RW conc.
R per detector n/a
RW per detector n/a
R per target gas n/a
RW per target gas n/a
R per target gas n/a
RW per target gas n/a
RW 110 %FSD conc.
RW per target gas n/a
RW -7 %FSD conc.
R per target gas n/a
R per target gas n/a
R per target gas n/a
RW 10 minutes
—
R n/a
RW -2 %FSD conc.
Technical Handbook