Touchpoint Plus Packaging; Packaging Components For Return To Manufacturer; Disposal (Weee Directive); System Construction - Honeywell Touchpoint Plus Wireless Technical Handbook

3020M5001_Iss 1_07/18

3.1.10 Touchpoint Plus Packaging


Touchpoint Plus outer packaging is made from cardboard. Facilities for recycling are widely available.

Touchpoint Plus inner packaging is made from Stratocell
foam can be recycled into new Stratocell

3.1.11 Packaging Components for Return to Manufacturer

Honeywell is unable to accept any consignment that does not conform to the European Classification,
Labelling and Packaging (CLP) Regulations (EC) 1272/2008.
Please consult your distributor, supplier, or the manufacturer if you require further advice.

3.1.12 Disposal (WEEE Directive)

The system contains Lithium batteries and a number of homogenous hazardous materials. These should be
disposed of carefully in accordance with the WEEE Directive and local laws and guidelines. Under no
circumstances can they be disposed of as domestic waste.

3.2 System Construction

This figure shows the basic building blocks of the Touchpoint Plus system. The optional Expansion Unit will
not have any of the items seen on the left hand (door) panel.
2
System General Description
1

Figure 9. System Layout Before Installation

1
Touchscreen
2
SD Card
3
SMPS
4
WIO Module
5
Relay Output Module
6
Power Terminal
®
, Low-Density Polyethylene (LDPE) foam. The
®
where such recycling facilities exist.
3
7
Main Module
8
mA Input Module
9
NA
10
Earth (Ground) Bus Bar
11
Battery On / Off Switch
12
Backup Battery
17
Touchpoint Plus Wireless
Technical Handbook
5
7
6
11
4
8
12
10