Testing Your System; Testing Sensors (Walk Test) - Honeywell Lyric LCP300-LC User Reference Manual

Before testing, the system should be disarmed and all protected doors and windows closed. The
systems should be in Ready to Arm state.
No alarm messages are sent to your alarm monitoring company during these tests.
Press Tools and enter the 4-digit Master User code. Press Advanced.
Testing Sensors
Home > Security > Tools > Advanced > Walk Test
Start by pressing Walk Test.
The Gateway's internal sounder loudly sounds and Walk Test – Home to Quit appears. The
Gateway then beeps every 30 seconds as a reminder that the system is in Test mode.
Note that Walk Test mode automatically quits after 4 hours.
Doors and Open each protected door and window in turn and listen for the set device
Windows chime from the Gateway. If
descriptor is announced. Identification of protection points with problems should
appear on the MyHome Gateway App screen. Notifications of problem zones
clear when the door or window is closed.
Motion Walk in front of each sensor and listen for three beeps and/or voice descriptors.
Sensors
The device's identification should appear on the display when it is activated. The
display clears when no motion is detected.
NOTE: If wireless motion detectors are in use, there is a 3-minute delay between
activations, which helps preserve battery life.
Fire/Carbon Follow the manufacturer's instructions to test these devices. When a device is
Monoxide activated, its identification should appear on the MyHome Gateway App screen.
sensors
When testing smoke detectors, keep the Gateway in test mode for at least one
minute (60 seconds) after testing the detector to avoid sending unwanted
alarm messages to your central station monitoring company.
If there is a problem with any sensor (no confirming sounds, no display), notify your service
company.
When all sensors have been checked (and doors and windows closed), no zone identification
numbers should be displayed.
Finish by pressing Home and entering the Master User code.

Testing Your System

NOTE: TESTING SHOULD BE PERFORMED WEEKLY.
(Walk Test)
PANEL VOICE is enabled, each zone's voice
IMPORTANT
46