Channel Configuration; Introduction - Honeywell Touchpoint Plus Wireless Technical Handbook

3020M5001_Iss 1_07/18

7.6 Channel Configuration

Note: Engineer or higher level access is required
Note: There is no calibration reminder in TPPL. A user can disable the calibration relevant warning by setting
the calibration interval to zero.

7.6.1 Introduction

Individual channel can be configured in two ways – either from the built in sensor catalogue (for Analogue
Input modules only), or by completing a full custom configuration.
When using the sensor catalogue, channel number and tag must be manually entered and then the rest of the
configuration is populated automatically when detector name and sensor type are selected from the pre-
defined list.
Note: You can always use the sensor catalogue as a starting point and then amend it afterwards (see section
'Ch.7.6.3 Editing a Configured Channel' and 'Ch. 14 Configurable Parameter Reference Guide).
To change any parameter, enter the new value and touch Apply to send it to the system. The system will then
return the value, which will be displayed on the screen, and the user must touch Update for the settings to
take effect. This requires the user to verify that the correct value has reached the system.
New values can be entered in various ways:

Free text (i.e. channel tag)

Numeric keypad

Check / uncheck a box (i.e. to toggle an alarm between latching and non-latching)

Select an option by checking a radio button

Select from a list of available options (i.e. channel number)
The configuration is designed to be simple to follow on the screen. However you can refer to Ch.15
Configurable Parameter Reference Guide to find detailed definitions of all the parameters, default settings and
available ranges.
Commissioning
54
Touchpoint Plus Wireless
Technical Handbook