Honeywell Touchpoint Plus Wireless Technical Handbook page 45

3020M5001_Iss 1_07/18 Touchpoint Plus Wireless
Technical Handbook
Operating Instructions
The Touchpoint Plus accepts standard SD cards of 2 to 32 GB (FAT32).
The SD card is used to store the system event history. Touchpoint Plus logs all events and all changes to
input readings. A notification will be given when the SD card is less than 50Mbytes space. If the card is not
replaced or not freed up, a further notification will be given when it is full, and when data is being overwritten.
Note: The SD Card must remain inserted during normal system operation as the on-board flash
memory is limited to a few minutes of events. When the card is full it should be replaced or freed up
almost immediately to avoid data loss.
Note: The SD Cards must be empty and setup by TPPL following first installation, and they should be used for
TPPL data only. Data can be transferred or copied to a PC via a Card Reader and the card reused, but care must
be taken not to overwrite previous data files, and a reliable backup system should be used.
Note: The SD card have to set unlocked for data logging
Note: It is suggested SD card format before using a SD card by TPPL. Menu>Maintenance>SD Card>Format
39