Honeywell Touchpoint Plus Wireless Technical Handbook page 63

Hide thumbs Also See for Touchpoint Plus Wireless:

Table of Contents

3020M5001_Iss 1_07/18

Note:

There are the Touchpoint Plus sensor catalog has selectable gases and Gasgroup 1~ GasGroup8 for

not listed flammable gases

Warning: When selecting a new target gas for units the sensor must be recalibrated

Warning: Do not use the TPPL Universal Transmitter in oxygen-enriched atmospheres. Concentrations

displayed will be adversely affected by oxygen depletion.

7.6.4 Configuring Relay output channels

Note: You need to complete Configuring input channels

Note: You need to complete Network setting for wireless nodes

To configure an individual channel:

1) Login as an engineer or higher level

2) Select Menu>Configuration>Channel settings.

3) Select the required a Relay Output Module

4) Select a required channel and touch 'Select'.

5) Set Enable a channel

6) Click 'Assign type' and select an assign type among 'Sensor', 'Monitor' or 'Wind sensor'

7) Set others and touch 'Finish'

8) Check all settings are correct what you set and select 'Apply'

9) Check all settings are correct what you set finally and select 'Update'

10) Repeat 5~9 for all Relay channels

Commissioning

Touchpoint Plus Wireless

Technical Handbook

Table of Contents

Chapters

Table of Contents