Drive Start-Up; Setup Wizard - YASKAWA CIPR-GA70C Series Initial Steps

11 Drive Start-Up

◆
Wiring the Main Circuit and Motor
Refer to Figure 10.3 for a view of the drive with line and load wiring.
WARNING
Electrical Shock Hazard. Do not connect terminals R/L1, S/L2, T/L3, U/T1, V/T2, W/T3, -, +1, +2, +3, B1, or
B2 to the ground terminal. Failure to obey can cause death, serious injury, or damage to equipment.
A - Terminal block (TB2-3)
B - Terminal block (TB2-2)
C - Terminal block (TB2-1)
D - DC bus voltage terminals
E - Drive ground terminals
F - Motor case ground
11 Drive Start-Up
◆

Setup Wizard

Refer to the motor nameplate to record the information in the following table before starting the drive.
Motor Rated Power
Motor Rated Voltage
Motor Rated Current
Motor Rated Frequency
EN 22
(configuration changes by drive
model)
Figure 10.3 Wiring the Line and Load
Item
G - Three-phase motor
H - Three-phase power supply
I - Fuses and RCD
J - Terminal block (TB1)
K - Terminal block (TB3)
L - Terminal block (TB4)
YASKAWA ELECTRIC TOEP C710617 17D YASKAWA AC Drive GA700 Initial Steps
Value
kW
V
A
Hz