YASKAWA CIPR-GA70C Series Initial Steps page 7

No. Name
LO/RE LED
E
LO/RE Selection Key
F
STOP Key
G
Left Arrow Key
Up Arrow Key/Down
Arrow Key
/
H
Right Arrow Key
(RESET)
ENTER Key
RUN Key
I
J
USB Terminal
K RJ-45 Connector
L Clock Battery Cover Cover for the customer-supplied clock battery.
WARNING
Sudden Movement Hazard. Remove all persons and objects from the area around the drive, motor, and
machine area before switching control sources when b1-07 = 1 [LOCAL/REMOTE Run Selection = Accept Existing RUN
Command]. Failure to obey can cause death or serious injury.
YASKAWA ELECTRIC TOEP C710617 17D YASKAWA AC Drive GA700 Initial Steps
Illuminates to identify when the drive is operating in LOCAL Mode.
The LED turns OFF when the drive is operating in REMOTE Mode.
Note:
• LOCAL Mode: The keypad controls the Run command and frequency reference. Use the keypad to
enter Run/Stop commands and the frequency reference command.
• REMOTE Mode: The control circuit terminal or serial transmission device controls the Run
command and frequency reference. Use the frequency reference source entered in b1-01 [Frequency
Reference Selection 1] and the Run command source selected in b1-02 [Run Command Selection 1].
Switches drive control for the Run command and frequency reference between the keypad (LOCAL) and
an external source (REMOTE).
Note:
• Stop operation in Drive Mode to enable the LO/RE Selection Key. Set o2-01 = 0 [LO/RE Key
Function Selection = Disabled] to disable
have a negative effect on system performance.
• The drive will not switch between LOCAL and REMOTE when it is receiving a Run command from
an external source.
Stops drive operation.
Note:
Uses a stop-priority circuit. Push
MFDI terminals. Set o2-02 = 0 [STOP Key Function Selection = Disabled] to disable the priority in
.
Moves the cursor to the left.
• Scrolls up or down to display the next item or the previous item.
• Selects parameter numbers, and increments or decrements setting values.
• Moves the cursor to the right.
• Continues to the next screen.
• Restarts the drive to clear a fault.
• Enters parameter values and settings.
• Selects menu items to move the user between keypad displays.
• Selects each mode, parameter, and set value.
Starts the drive in LOCAL mode.
Starts the operation in Auto-Tuning Mode.
Note:
Push on the keypad to set the drive to LOCAL Mode before using the keypad to operate the
motor.
Insertion point for a mini USB cable. Use the mini USB cable to connect the drive to a PC.
Connects the keypad directly to the drive.
Functions
when switching from REMOTE to LOCAL will
to stop the motor even when a Run command is active at
6 Keypad
EN
EN 7