Usb Module - Lenze i550 Series Project Planning Manual

Accessories
Operation and diagnostics

USB module

USB module
Interface to the PC
The USB 2.0‑connecting cable is used to connect the inverter with a PC with the "EASY
Starter" Lenze Engineering Tool. The "EASY Starter" serves to configure the inverter via graphi-
cal interfaces. They create diagnostics with trend functions or monitor parameter values.
Parameterising without supplying the inverter with voltage: If you connect the inverter
directly to the PC without a hub, the USB interface of the PC is sufficient for the voltage supply
in many cases.
USB module
Order code
I5MADU0000000S
Connecting cable
Order code
EWL0085/S
EWL0086/S
Inverters with network option EtherCAT, PROFINET or EtherNET/IP must be sup-
plied with an additional voltage for setting parameters if a connection cable lon-
ger than 3 m is used.
Please observe the following for USB modules labelled as "PRE-SERIES": Inver-
ters with network option EtherCAT, PROFINET or EtherNET/IP must always be
supplied with an additional voltage for setting parameters.
240
Type
Parameter setting without voltage supply of the inverter is possible.
USB 2.0 connecting cable required
Length Type
3 m
USB 2.0‑connecting cable (A-plug to micro B-plug)
5 m