Replacing The Control Panel Cable - Planmeca Intra Technical Manual

PARTS REPLACEMENT & REPAIR
8.5

Replacing the control panel cable

1. Press the clip of the connector (figure 29, 1) and pull the socket from the terminal of the
generator box (figure 29, 2).
2. Detach the connector from the control panel in the same way as from the generator box.
3. Connect the new cable to the generator box and to the control panel.
CAUTION Do not connect any other equipment to the terminal of the generator
box.
Figure 29
48 Planmeca Intra X-ray unit Technical Manual