Table 1-5 Simotion D410 Interfaces - Siemens SIMOTION D410 Manual

Description
1.3 SIMOTION D410 DP display
Interfaces
The SIMOTION D410 DP interfaces are described in the following tables.
Table 1-5
Interface
Digital inputs/outputs
X121
DRIVE-CLiQ interface
X100
PROFIBUS DP interface
X21
Power Module Interface
(PM-IF)
Encoder interface (HTL/TTL)
X23
EP terminals/temperature
sensor connection
X120
Power supply connection
X124
Measuring sockets
T0, T1, T2 and M
Nameplates
The following figure shows you all the information included on the nameplates located on the
side of the unit.
Figure 1-3
18
SIMOTION D410 interfaces
Description
4 digital inputs: Socket to connect switches or proximity sensors
•
4 digital inputs/outputs: 12-pin socket to connect actuators and
•
sensors
8-pin RJ45plus socket to connect DRIVE-CLiQ nodes
9-pin SUB-D socket to connect to PROFIBUS DP
8-pin direct connector to connect to a blocksize power module
15-pin SUB-D socket to connect HTL and TTL encoders.
8-pin Mini Combicon to connect input terminals ("safe standstill") or
to connect temperature sensing via KTY or PTC
4-pin screw terminal connection to connect the 24 V DC load power
supply
Sockets to output analog signals
SIMOTION D410 nameplate
D410
Manual, 03/2007 Edition