Operator Controls; Mode Selector Switch; Table 2-1 Mode Selector Switch Settings - Siemens SIMOTION D410 Manual

Operation (hardware)

2.2 Operator controls

2.2 Operator controls
2.2.1

Mode selector switch

DIL switches
The mode selector switch function is realized in SIMOTION D410 by a DIL switch
(DIL = Dual In Line Package). The DIL switch is located in the lower front area of the
SIMOTION D410 (see "Overview of operator controls and indicators").
To set the SIMOTION operating mode, a binary code is used, which is entered via the DIL
switch (switch S1 - S3).
Figure 2-2
The following table contains the operating modes that can be set and the associated code.
Table 2-1 Mode selector switch settings
Operating S1 S2
mode
RUN 1 1
(3 switch = ON)
STOPU 110 / 101 / 011
(2 switch = ON)
STOP 100 / 010 / 001
(1 switch = ON)
MRES 0 0
(0 switch = ON)
24
DIL switches
S3 Description
1 SIMOTION D410 runs the user program and all connected system performances:
Read process image of inputs.
•
Execution of the user programs assigned to the execution system.
•
Write process image of outputs.
•
The technology packages are active in this state. They can execute commands from the
user program.
SIMOTION D410 does not run a user program.
The technology packages are active. Test and commissioning functions can be
•
executed. The user program is not active.
The I/O modules are in a secure state.
•
SIMOTION D410 does not run a user program.
It is possible to load a complete user program.
•
All system services (communications, etc.) are active.
•
The I/O modules are in a secure state.
•
The technology packages are inactive, i.e., all enables are deleted. No axis motions
•
can be executed.
0 Overall module reset
You can reset SIMOTION D410 via the MRES switch setting. Observe the operating
sequence in the Commissioning Manual,
SIMOTION D410
, /1/.
D410
Manual, 03/2007 Edition