Table 1-4 Components On Drive-Cliq - Siemens SIMOTION D410 Manual

Description
1.2 System components
DRIVE-CLiQ
SIMOTION D410 can communicate via DRIVE-CLiQ interface to the following components:
Table 1-4
Components
Drive units
SINAMICS S120 AC DRIVE
(with CUA31)
TM15 and TM17 High Feature
terminal modules
TM31 terminal module
TM41 terminal module
Sensor Module Integrated (SMI)
Sensor Module Cabinets (SMC)
DMC20
Note
Note that SIMOTION D410 does not support the CX32 expansion!
16
Components on DRIVE-CLiQ
Function
... convert speed setpoints into signals for controlling the motor
and supply the power required to operate the motors. The
AC DRIVE component PM340 is connected via CUA31. No more
than one PM340 can be connected. Chassis power module is
connected via DRIVE-CLiQ.
Note: Booksize components are not supported!
The TM15 and TM17 High Feature terminal modules can be
used to set up inputs of measuring inputs and outputs of output
cams. In addition, these terminal modules provide drive-related
digital inputs and outputs with short signal delay times.
... enables terminal expansion via DRIVE-CLiQ (additional
analog and digital inputs/outputs).
... enables terminal expansion (analog and digital inputs/outputs)
and encoder simulation via DRIVE-CLiQ.
The integrated sensor module delivers the encoder signals
directly as DRIVE-CLiQ signals.
... converts the encoder signals into DRIVE-CLiQ signals.
... expands the number of DRIVE-CLiQ nodes
D410
Manual, 03/2007 Edition