Simotion Compactflash Card - Siemens SIMOTION D410 Manual

Note
The factory DIL switch setting (switches S1 to S7) is 1110000. As a rule, it is not necessary
to adjust this switch. Use the SIMOTION SCOUT Engineering System to set the operating
mode (at switch setting 1110000).
Switches S4 - S7 are not used in SIMOTION D410 and must be set to "0" (OFF).
SIMOTION SCOUT mode selector switch
In SIMOTION SCOUT, you can control the SIMOTION D410 operating state using a
software switch.
To set the operating state via SIMOTION SCOUT, see the Configuring Manual,
SCOUT
2.2.2

SIMOTION CompactFlash card

CompactFlash card slot
The CompactFlash card (CF card) is inserted into the plug-in module over the blanking plate
(see "Overview of operator controls and indicators").
CF card features
The CF card is mandatory to run SIMOTION D410. The CF card must be ordered as a
separate component; it is not included in the SIMOTION D410 scope of delivery.
The SIMOTION firmware is located on the CF card.
CF card functions:
• Backup technology packages and user data
• Update (e.g., SIMOTION firmware update)
D410
Manual, 03/2007 Edition
, /9/.
Note
The CF card may only be unplugged and plugged in when the system is switched off
(zero current)!
If the CF card is being accessed, the RDY-LED on the SIMOTION D410 flashes green
(see chapter "Error and status indicators").
Operation (hardware)
2.2 Operator controls
SIMOTION
25