Mitsubishi Electric CR800 Series Ethernet Function Instruction Manual page 23

2.2.4. Parameter setting example 2-1
(When the data link function is used: When the controller is the server)
Shows the example of the setting, when the controller is server by the data link function.
Robot controller IP address
Personal computer IP address
Robot controller port No.
Communication line No.
<For MELFA-BASIC V/VI>
OPEN command COM No.
Parameter
NETIP
NETPORT
CPRCE13
COMDEV
Next, set the personal computer IP address to 192.168.0.10. Set this value on the Network Properties screen.
The personal computer IP address is set with the Windows TCP/IP Property Network setting (property in network
computer). Because the set-up screen differs with versions of Windows, refer to the manuals enclosed with Windows, etc.,
for details on setting this address.
Refer to the instruction manuals enclosed with the personal computer support software for details on setting and using the
personal computer support software.
Conditions for example 2-1
192.168.0.20
192.168.0.10
10003
COM3:
Parameter setting for example 2-1
Before/after
change
Before 192.168.0.20
after 192.168.0.20 (unchanged)
Before 10000,10001,10002,10003,10004,10005,10006,10007,10008,10009
10000,10001,10002,10003,10004,10005,10006,10007,10008,10009
after
(unchanged)
Before 0
after 2
Before , , , , , , ,
after , , OPT13, , , , ,
2 Preparation before use
Parameter value
2-9