Mitsubishi Electric CR800 Series Ethernet Function Instruction Manual page 113

■ Slave station parameter settings
1. In RT ToolBox3, open "Online" → "Parameter" → "Ethernet", and set the IP address of the robot.
Here, the initial value 192.168.0.20 is being used. If you do not change the initial value, it is not necessary to
press Write.
2. Next, open "Online" → "Parameter" → "Field Network Parameter" → "CC-Link IE Field Basic", and change the
function selection to "Enable". Lastly, press "Write" and then reset the power of the robot controller.
3 Description of functions
3-87