2. Preparation before use
What is done before use is described.
Connection of Ethernet cable
↓
Parameter setting
2.1. Connection of Ethernet cable
As shown below, connect the Ethernet cable to the connector.
When the hub is used, use the straight cable. Or when the personal computer and controller are connected to each other
one to one, use the cross cable.
<CR800-D controller>
<CR800-R controller>
Robot CPU unit front
<CR800-Q controller>
Robot CPU unit front
... Refer to 2.1.
... Refer to 2.2.
CR800-D controller front
LAN connect
LAN connect
PERIPHERAL I/F connect
2 Preparation before use
2-1