Wiring Method Of Cn10A/Cn10B Connectors - Mitsubishi Electric MR-D30 Instruction Manual

3. SIGNALS AND WIRING

3.7 Wiring method of CN10A/CN10B connectors

When wiring to CN10 and CN10B, use the connector DFMC 1,5/9-STF-3,5 (Phoenix Contact) packed with
the servo amplifier.
(1) Fabricating wire insulator
Use a wire with AWG 24 to 16, and strip the wire end to make the stripped length 10 mm ± 0.5 mm.
(2) Inserting wire
Insert the wire while pressing the release button with a flat-blade screwdriver with a blade width of 2.0
mm to 2.5 mm. When the wire is inserted all the way, remove the screw driver.
It is recommended using the following screwdriver manufactured by Phoenix Contact: model: SZS
0,4X2,5, product No.: 1205037.
(3) Removing wire
Pull out the wire while pressing the release button with the flat-blade screwdriver.
Upper row
Lower row
Release button
Wire insertion hole
3 - 16
Flat-blade
Wire
screwdriver
Remove the screwdriver
to connect.