Drive Enclosure; Figure 115 Host Interface Installation Diagram (Eternus Dx500 S4/Dx500 S3); Figure 116 Host Interface Installation Diagram (Eternus Dx600 S4/Dx600 S3) - Fujitsu ETERNUS DX500 S4/DX600 S4 Design Manual

5. Hardware Configurations
Standard Installation Rules
The diagram below shows a host interface installation.
ETERNUS DX500 S4/DX500 S3
•
Install the host interfaces in CA#0 and then CA#1 according to the priority order.
The configuration is the same for Controller 0 (CM#0) and Controller 1 (CM#1).

Figure 115 Host Interface Installation Diagram (ETERNUS DX500 S4/DX500 S3)

ETERNUS DX600 S4/DX600 S3
•
Install the host interfaces in CA#0, CA#1, CA#2, and CA#3 in ascending order according to the priority order.
The configuration is the same for Controller 0 (CM#0) and Controller 1 (CM#1).

Figure 116 Host Interface Installation Diagram (ETERNUS DX600 S4/DX600 S3)

Drive Enclosure

This section describes the standard installation rules for drive enclosures.
Drive enclosures can be installed without installing any drives.
■
Installation Order
2.5" type, 3.5" type, and high-density drive enclosures can be installed together in the ETERNUS DX.
1
High-density drive enclosures (12Gbit/s)
2
High-density drive enclosures (6Gbit/s)
3
2.5" type drive enclosures
4
3.5" type drive enclosures
Drive enclosures are installed above the controller enclosure according to the priority order.
FUJITSU Storage ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems Design Guide (Basic)
CA#0
Controller 1 (CM#1)
CA#0
Controller 0 (CM#0)
Rear view of a controller enclosure
CA#2
CA#0
Controller 1 (CM#1)
CA#2
CA#0
Controller 0 (CM#0)
Rear view of a controller enclosure
Copyright 2019 FUJITSU LIMITED
CA#1
CA#1
CA#3
CA#1
CA#3
CA#1
188
P3AM-7722-25ENZ0