Config 5 - Realtek RTL8169 Manual

6.16 CONFIG 5

(Offset 0056h, R/W)
This register, unlike other Config registers, is not protected by 93C46 Command register. I.e. there is no need to enable the
Config register write prior to writing to Config5.
Bit R/W
7 -
6 R/W
5 R/W
4 R/W
3:2 -
1 R/W
0 R/W
Bit1 and bit0 are auto-loaded from the EEPROM Config5 byte to the RTL8169 Config5 register.
2002/03/27
Symbol
- Reserved
BWF Broadcast Wakeup Frame:
1: Enable Broadcast Wakeup Frame with mask bytes of only DID
field = FF FF FF FF FF FF.
0: Default value. Disable Broadcast Wakeup Frame with mask bytes
of only DID field = FF FF FF FF FF FF.
The power-on default value of this bit is 0.
MWF
Multicast Wakeup Frame:
1: Enable Multicast Wakeup Frame with mask bytes of only DID
field, which is a multicast address.
0: Default value. Disable Multicast Wakeup Frame with mask bytes
of only DID field, which is a multicast address.
The power-on default value of this bit is 0.
UWF Unicast Wakeup Frame:
1: Enable Unicast Wakeup Frame with mask bytes of only DID
field, which is its own physical address.
0: Default value. Disable Unicast Wakeup Frame with mask bytes
of only DID field, which is its own physical address.
The power-on default value of this bit is 0.
- Reserved
LANWake LANWake Signal Enable/Disable:
1: Enable LANWake signal.
0: Disable LANWake signal.
PME_STS PME_Status bit: Always sticky/can be reset by PCI RST# and
software.
1: The PME_Status bit can be reset by PCI reset or by software.
0: The PME_Status bit can only be reset by software.
Description
27
RTL8169
Rev.1.21