Setting Ied Ip Address In The Project - ABB Relion 630 Series Engineering Manual

1MRS756800 F
4.6.5
630 series
Engineering Manual

Setting IED IP address in the project

There are two alternatives to set IP address of the IED object in PCM600. The used
alternative depends on the time at which the IP address is available.
The IED object in PCM600 must have the same IP address and subnetwork mask as
the front or rear port on the physical IED to which the PC is connected. The IP address
of the physical IEDs front and rear port can not be set from PCM600 but only from
LHMI.
• Via the first window of the wizard when including a new IED in a project.
IEC09000365 V2 EN
Figure 24: Alternative 1: IP address via first Wizard window
• Via the IP address property of the IED in the Object Properties window.
IEC09000362 V1 EN
Figure 25: Alternative 2: IP address via IED Object Properties window
Setting up a project
IEC09000365-2-en.vsd
IEC09000362-1-en.vsd
Section 4
47