Changed Functions - ABB Relion 630 Series Engineering Manual

Section 10
Configuration migration
10.2.7
142

Changed functions

Table 4: Functions changed in the configuration after the migration from 630 series Ver. 1.0 to
630 series Ver. 1.1
Function Implication
1)
SCILO All instances are removed from ACT.
1)
SPGGIO All instances are removed from ACT.
1)
DPGGIO All instances are removed from ACT.
The function is removed from the Application Configuration tool. The signal is now
1)
PSM_BATSUP available in the PSM module analog inputs.
The function is removed from the Application Configuration tool. The signal is now
1)
PSM_TCS available in the PSM module analog inputs.
The function is removed from the Application Configuration tool. The signal is now
1)
A3RADR available in the PSM module analog inputs.
DEFLPDEF New setting Base value Sel phase added.
DEFHPDEF New setting Base value Sel phase added.
INTRPTEF Setting Ground start value renamed to Voltage start value.
SCEFRFLO Amount of recorded data banks increased.
DARREC CB closed Pos status setting default value changed to 0.
DSTPDIS Setting Voltage Mem time added.
Minimium values for Operate time delay, Dead line time and Cur voltage Det time
CVRSOF and step resolution for all time settings.
MNSPTOC DO type corrected.
Removal of setting Base value Sel Res. Now internal minimum current levels are
LREFPNDF also based on phase base values.
Harmonized default value for setting Scheme type with the default of the same
RESCPSCH setting in DSOCPSCH.
GNRLCSWI Changed default for input SYNC_OK to TRUE.
SSCBR DOs PosOpn and PosCls removed from the default data set.
The time quality for mandatory data SeqA.c3 (showing always zero amplitude) is
CSMSQI corrected.
The time quality for mandatory data SeqV.c3 (showing always zero amplitude) is
VSMSQI corrected.
1) The function must always be reassigned if it has been used in the earlier configuration.
Table 5: Functions changed in the configuration after the migration from 630 series Ver. 1.1 to
630 series Ver. 1.2
Function Implication
1)
EPDMMTR Function is removed from ACT.
COM Debounce time lower limit changed for binary input.
BIO Debounce time lower limit changed for binary input.
MAPGAPC Under-operation mode corrected.
MNSPTOC IEC and ANSI symbols updated.
Table continues on next page
1MRS756800 F
630 series
Engineering Manual