Toro Greensmaster eTriFlex 3360 Service Manual page 224

Adjusting the Brake Linkage (continued)
Chassis: Adjustments
A. Check the brake rod assembly spring length and adjust as necessary;
36 to 40 mm (1.44 to 1.56 inch).
g283626
1. Brake rod
2. Brake rod spring
3. Upper brake rod clevis
B. Use new cotter pins and install the brake rod assembly to the upper
brake arms only.
5. Remove the cotter pin and clevis pin from the lower brake rod clevis. Discard
the cotter pin.
Adjust each brake rod individually.
6. Loosen the hex nut at the upper brake rod clevis and adjust the brake rod so
the hole in the lower brake rod clevis is at the top of the slot in the brake lever.
g283628
1. Front traction motor – RH
2. Lower brake rod clevis
Figure 97
4. Hex nut
5. Lower brake rod clevis
IMPORTANT
Figure 98
(view from rear)
3. Brake lever
Page 6–4 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A