Toro Greensmaster eTriFlex 3360 Service Manual page 266

Servicing the Cutting Unit Suspension Assembly (continued)
Installing the Cutting Unit Suspension Assembly
Chassis: Service and Repairs
g286889
1. Lower A arm
2. Counterbalance bracket
7. Install the cutting unit; refer to the traction unit Operators Manual.
8. Install the grass basket.
Refer to Figure 122 for this procedure.
1. Ensure all suspension components are correctly assembled.
2. Secure the suspension assembly to the machine with the 3 flange head
screws previously removed. Tighten the screws from 69 to 81 N·m (50 to
60 ft-lb).
3. Install the front wheel if previously removed; refer to
the Wheels (page 6–8).
4. If the stabilizer springs are removed, support the suspension assembly so the
spring bracket mounting hole is 145 mm (5.72 inch) from the rear of the pivot
mount (transport position). Then, position the bracket so the center of the
spring end is 222 mm (8.74 inch) from the rear of the pivot mount. Secure
the spring bracket in position with the flange head screw.
Figure 124
3. Counterbalance tensioner
4. Clevis pin
Page 6–46
Removing and Installing
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A