Aligning the Rear Wheel Caster Fork
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A
g291172
1.
Rear caster fork
2.
Wheel Hub
1. Remove the rear wheel; refer to
6–8).
2. Clamp a straight edge to the rear wheel hub flange.
3. Rotate the caster fork by hand until the straight edge aligns with the lower
mounting bolt on the center (rear) cutting unit suspension mount plate.
4. Adjust the steering position sensor; refer to
Sensor (page
5–18).
Figure 101
3.
Straight edge
4.
Center (rear) cutting unit suspension
mount plate
Removing and Installing the Wheels (page
Page 6–7
Adjusting the Steering Position
Chassis: Adjustments