Toro Greensmaster eTriFlex 3360 Service Manual page 301

Drive and Support Components (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A
g285506
1. Drive shaft assembly
2. Reel shaft
B. Insert a long-handled pry bar (3/8 x 12 inch with screwdriver handle
recommended) through the bottom of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move.
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
C. Move the pry bar against the weld side of the reel support plate closest
to the rear roller brush drive shaft.
D. Rest the handle of the pry bar against the front roller and use the large
hex (1.375 inch) to loosen the drive shaft assembly.
E. Tip the cutting unit back onto its rollers.
F. Assemble the drive shaft and drive adapter (machines without a universal
groomer) with a medium strength thread locking compound (Loctite 243
or equivalent) and tighten from 150 to 163 N∙m (110 to 120 ft-lb).
Figure 154
3. Weld side of reel support plate
4. Pry bar
IMPORTANT
Page 7–33 DPA Cutting Units: Service and Repairs