Toro Greensmaster eTriFlex 3360 Service Manual page 190

Removing the Starter/Generator Assembly
g286730
1. Engine frame assembly
2. Cap screw
3. Cap screw ( 2 each)
4. Isolating mount – rear
5. Lock nut (3 each)
Electrical System: Service and Repairs
6. Cap screw
7. Clamp
8. Lock nut
9. Flange nut (4 each)
10. Wire harness connector
Refer to Figure 80 for this procedure
1. Park the machine on a level surface, lower the cutting units, set the key
switch to the O position and remove the key from the key switch.
FF
2. Unplug the 48V battery disconnect; refer to
5–4).
3. Disconnect the negative (–) battery cable from the 12V system battery; refer
to Removing and Installing the 12V System Battery (Model 04580) (page
5–116).
4. Remove the exhaust system; refer to
4–10).
Figure 80
11.
12.
13.
14.
Removing the Exhaust System (page
Page 5–92
Isolating mount – front (2 each)
Cap screw (4 each)
Flat washer (3 each)
Cap screw (2 each)
48V Battery Disconnect (page
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A