Toro Greensmaster eTriFlex 3360 Service Manual page 106

CAN bus Communications (continued)
Electrical System: General Information
g287505
1. CAN bus isolation module
2. CAN A – 12V side
3. CAN B– 48V side
4. CAN bus terminator resistor (4 each)
5. T1: Primary controller
6. SC1: InfoCenter
7. CAN A diagnostic port
8. T2: Cutting Unit 1 motor controller (center) 19.
9. T3: Cutting Unit 2 motor controller (left)
10. T4: Cutting Unit 3 motor controller (right)
11. T5: Traction 3 motor controller (optional)
The Toro DIAG electronic control diagnostics service system is available to
Authorized Toro Distributors to support machine fault diagnosis and maintenance
services of the machine electrical control devices. The Toro DIAG connector is
located at the rear of the console armrest.
Figure 22
12. T6: Starter/Generator controller (model
03580 only)
13. T6: Pre–charge controller (model 03590
only)
14. SC2: Lift/Lower 1 actuator controller
(center)
15. SC2: Lift/Lower 2 actuator controller (left)
16. SC2: Lift/Lower 3 actuator controller (right)
17. SC5: Traction 1 motor controller (right)
18. SC6: Traction 2 motor controller (left)
SC7: Steering motor controller
20. SC8: Battery controller (model 03590 only)
21. CAN B diagnostic port
Page 5–8 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A