Toro Greensmaster eTriFlex 3360 Service Manual page 94

Removing the Engine (continued)
Engine (Model 04580): Service and Repairs
A. Disconnect the starter/generator from the machine wire harness. Check
the starter/generator and the harness connector for damage or corrosion
and clean or repair as necessary.
B. Remove the fasteners securing the engine frame assembly to the 3
isolating mounts.
The engine frame assembly weighs approximately 68 kg (150 lb).
Use an appropriate lift to remove the engine frame assembly.
C. Remove the engine frame assembly from the machine.
10. Remove the fasteners securing the drip pan to the engine frame (item 3
and 4 in Figure 15).
11. Remove the starter/generator drive belt:
A. Tilt the Operator seat forward and remove the pulley cover (item 6 in
Figure 15).
B. Loosen the hex nuts and extend the adjustment pin as far as possible to
relax the extension spring.
g286883
1. Generator drive belt
2. Generator pulley
3. Engine pulley
4. Engine frame
C. Loosen the 4 cap screws (item 8) securing the starter/generator to
the engine frame. Loosen the cap screws only enough to allow the
starter/generator to rotate on the engine frame.
D. Rotate the starter/generator clockwise (when viewed from above) and slip
the starter/generator drive belt off of the engine pulley.
CAUTION
Figure 17
5. Hex nut (2 each)
6. Adjustment pin
7. Extension spring
8. Cap screw (4 each)
Page 4–14 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A